Ingeteam GB132-C1, Инструкция по установке и эксплуатации

Страница: 10 / 72

10
Receipt of the unit and storage Ingeteam
ABA2013IQM01_ - Installation and usage manual
4. Receipt of the unit and storage
4.1. Reception
Keep the unit in its packaging until immediately before installation.
4.2. Equipment identification
The serial number of the equipment is its unique identifier. This number must be quoted in any communication
with Ingeteam.
The unit’s serial number is marked on the specifications plate:
4.3. Transport damage
If the unit has been damaged during transport, proceed as follows:
1. Do not proceed with the installation.
2. Notify the distributor immediately within 5 days of receipt of the unit.
If ultimately the unit has to be returned to the manufacturer, the original packaging must be used.
4.4. Storage
Failure to follow the instructions provided in this section may lead to damage to the unit.
Ingeteam accepts no liability for damage resulting from the failure to follow these instructions.
If the unit is not installed immediately after reception, the following points should be taken into account in order to
avoid damage:
• In order to permit correct conservation of the units, they must not be removed from their original
packaging until it is time to install them.
• Deterioration of the packaging (tears, holes, etc.) prevents the units from being kept in optimum
conditions before installation. Ingeteam accepts no liability for any consequences arising from the deterioration
of packaging.
• Keep the unit free of dirt (dust, shavings, grease, etc.) and away from rodents.
• Keep it away from water splashes, welding sparks, etc.
• Cover the unit with a breathable protective material in order to prevent condensation due to ambient
humidity.
• Units in storage must not be subjected to weather conditions other than those indicated below:
Environmental conditions
Minimum temperature −20 ºC
Minimum surrounding air temperature −20 ºC
Maximum surrounding air temperature 70 ºC
Maximum relative humidity without condensation 95%
• It is very important to protect the unit from chemical products which can cause corrosion, as well as from
salty atmospheres.
• Do not store the unit outdoors.