Ingersoll-Rand TRANE AFDJ, Инструкция по установке, эксплуатации и обслуживанию

Страница: 51 / 66

Pre-Commissioning Start-Up
AFDJ-SVU01D-EN 51
Drive Commissioning
1. A pre-installation meeting with the customer to
review:
• The Rockwell Automation Start-up Plan
• The Start-up Schedule
• The Drive(s) installation requirements
2. Inspect the drive’s mechanical and electrical devices.
3. Verify internal connections within the drive and verify
wiring.
4. Verify critical mechanical connections for proper
torque requirements.
5. Verify and adjust mechanical interlocks for permanent
location.
6. Confirm all inter-sectional wiring is connected
properly.
7. Re-verify control wiring from any external control
devices.
8. Confirm cooling system is operational.
9. Verification of proper phasing from input voltage
source to drive.
10. Confirm cabling of drive to motor, isolation
transformer, and line feed.
11. Collect test reports indicating megger/hi-pot test has
been performed on line and motor cables.
12. Control power checks to verify all system inputs such
as starts/stops, faults, and other remote inputs.
13. Apply medium voltage to the drive and perform
operational checks.
Note: At this point, coordinate with Rockwell so that unit
is charged and oil pump is working.
14. Bump motor for rotation check and tune drive to the
system attributes. (If the load is unable to handle any
movement in the reverse direction, the load should be
uncoupled prior to bumping the motor for directional
testing).
15. Run the drive motor system throughout the
operational range to verify proper performance.
Note: Customer personnel will be required on-site to
participate in the start-up of the system.
16. Log operation of chiller and drive for startup
documentation.