Ingersoll-Rand THERMO KING Precedent C-600, Руководство оператора

Страница: 96 / 148

96 TK 56218-2-OP-EN
Hourmeter Name Definition
Electric Reminder 1 User Programmable - The number of
hours before an Electric Run Time
Maintenance Reminder 1 occurs.
Electric Reminder 2 User Programmable - The number of
hours before an Electric Run Time
Maintenance Reminder 2 occurs.
IIm mp po orrtta an ntt:: If a programmable hourmeter is not enabled or the view for that
hourmeter is not turned on it will not appear in the display
sequence.
Mode
The Mode Menu allows the operator to change the unit operating modes
that have been enabled in Guarded Access. Only Operating Modes that have
been enabled from the Guarded Access > Main Menu Configuration Menu
will be shown.
• Turns Off Cycle Sentry Mode/Turns On Cycle Sentry Mode (If Cycle
Sentry is turned Off unit runs in Continuous). Note that selecting Cycle
Sentry Mode or Continuous Mode can also be accomplished using the
Cycle Sentry Key to the right of the display.
• Allows temperature to be displayed in either Fahrenheit or Celsius
degrees (if enabled from the Guarded Access > Main Menu Configuration
Menu).
• Allows the optional Fresh Air Exchange door to be opened or closed (if
enabled from the Guarded Access > Hardware Configuration Menu).
• Allows Keypad Lockout to be selected (if enabled from the Guarded
Access > Main Menu Configuration Menu).
• Allows Sleep Mode to be set up and started (if enabled from the
Guarded Access > Main Menu Configuration Menu).
When shipped from the factory, only the Cycle Sentry/Continuous Mode is
enabled.
If OptiSet Plus is in use, some modes may not be available.
To return to the Main Menu press the EXIT Key. To return to the Standard
display press the EXIT Key again.
Using the Change Mode Menu
Mode changes are made using the Mode Menu. From the Standard Display,
press the MENU Key (
Figure 117, p. 97 ).
O Op pe erra attiin ng g IIn nssttrru uccttiio on nss