Ingersoll-Rand S9V2B040U3VSAA, Руководство по установке

Страница: 89 / 104

18-CE03D1-1A-EN 89
1. Connect PS2 tubing to switch and new sensing location. Use
additional tubing in ship with bag, if necessary.
Important: Cut to length but insure there is a rise in the tubing to
avoid condensed flue gases from entering pressure
switch.
2. Remove port cap on the right side of inducer and connect inducer
condensate tubing. Connect other end of inducer condensate
tubing to top port on the condensate trap. Cut tubing to length, if
necessary.
3. Install previously removed port cap onto bottom port of the
inducer. (As viewed in upflow)
4. Connect condensate pressure switch tubing to pressure port on
the condensate trap. Cut to length, if required.
5. Remove port plug from rain gutter and install in new position on
opposite side of the rain gutter.
6. Connect rain gutter condensate hose to the rain gutter and the
lower port of the condensate trap. Route rain gutter condensate
hose to the right of the inducer motor.
3
4
2
1
5
6
F Fu urrn na acce e C Co om mb bu ussttiio on n A Aiirr E Ex xh ha au usstt O Op pttiio on nss