EN-21
80446339
Rev B
EN
Figure 27: Controller Interface
Starting the compressor
Upon power up, the controller will carry out a series of checks, and the
message CHECKING MACHINE will show on the display. If all the check
parameters are satisfactory, the display will then show READY TO START.
Depress the start button (2) on the controller compressor. The compressor
will start and automatically load.
Stopping the compressor
Depress the STOP button () which will automatically unload the compressor
for 10 seconds before stopping.
Switch off the main electrical isolation switch.
Stopping the compressor in an emergency
If the compressor has to be stopped in an emergency DEPRESS THE
EMERGENCY STOP BUTTON (1).
This will over–ride the normal unload/stop button and will immediately stop
the compressor without the 10 second delay.
Re–starting after an emergency
If the compressor has been switched off because of a compressor
malfunction, then identify and correct the fault before attempting to re–start.
If the compressor has been switched off for reasons of safety, then ensure
that the compressor can be operated safely before re–starting.
Refer to the PRIOR TO STARTING and STARTING THE MACHINE instructions
earlier in this section before re–starting the compressor.
110812.16.23
Содержание R132
Страница 45: ...110812 16 23...
Страница 46: ...110812 16 23...
Страница 48: ...ingersollrandproducts com 2012 Ingersoll Rand plc 110812 16 23...