Ingersoll-Rand LC2A015S, Информация по техническому обслуживанию продукции

Страница: 4 / 20

INSPECTION REPORT
Ingersoll Rand Liftchain Industrial Air Hoist
Model Number: Date:
Serial Number: Inspected by:
Reason for Inspection: (Check Applicable Box)
1. Scheduled Periodic Inspection ( ___ Quarterly ___ Semiannually ___ Yearly)
Operating Environment:
Normal ___ Heavy ___ Severe ___
2. Discrepancy(s) noted during Frequent Inspection
3. Discrepancy(s) noted during maintenance
4. Other: ___________________________
Refer to the Product Information and Parts Information Manual and “INSPECTION” section for the general inspection criteria. Also, refer to appropriate National Standards and
Codes of Practice. If in doubt about an existing condition, contact the nearest
Ingersoll Rand distributor or the factory for technical assistance.
COMPONENT
CONDITION CORRECTIVE ACTION
NOTES
Pass Fail Repair Replace
Fasteners
Gears
Shafts
Bearings ---
Load Bearing Sheave
Chain Guides
Springs ---
Covers, Housings
Hooks ---
Top
Actual Hook Throat Width: ________ inches / ________ mm
(Refer to Table 3 ‘Hook Throat Normal and Discarded Width’ on page 2 for minimum/maximum acceptable widths.)
Hook Twist
--- (maximum 10%)
Hook Crack Test Method Used: Dye Penetrant ________ Magnetic Particle ________ Other: ________
Bottom
Actual Hook Throat Width: ________ inches / ________ mm
(Refer to Table 3 ‘Hook Throat Normal and Discarded Width’ on page 2 for minimum/maximum acceptable widths.)
Hook Twist
--- (maximum 10%)
Hook Crack Test Method Used: Dye Penetrant ________ Magnetic Particle ________ Other: ________
Hook Latch ---
Brake (100% Load Test) ---
Brake (Visual Inspection)
Tail Pin (End Anchor)
Load Chain: ---
Working length(s) maximum wear: ________ inches / ________ mm
(Refer to Table 4 ‘Load Chain Normal and Discard Length’ on page 2.)
Supporting Structure
Labels and Tags ---
Other Components (List in NOTES
section)
Testing: Pass Fail NOTES
Operational (No Load)
Operational (100% Load)
Operational (Maximum Test Load*)
* Testing to more than 100% of rated capacity may be required to set overload device.
This form may be photocopied and used as an inspection record.
4 Form MHD56279 Edition 4