SKYZER TECHNOLOGIES
PAGE 58 OF 140
INGENICO Tetra PTS190 Paymark Operating GuideVersion 1.02
6.11 Remote Key Injection (PKMS)
The Ingenico Move 5000 terminal supports Remote Key Injection technology to
enable automated injection of security keys from Paymark.
6.11.1
Remote Key Injection (PKMS) Configuration
This function is used to configure the Remote Key Injection operation and can
be performed through Dial-up, TCP-IP (Broadband) and GPRS mode.
6.11.2
Dial-up RKI Configuration
Step
Terminal Display
Description
1.0
Press
FUNC
2.0
FUNCTION?
Enter
7418
, press
ENTER
3.0
MULTI MERCHANT
SETUP
Terminal is now in configuration mode. Go to following Steps to proceed or Press
CANCEL
to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
4.0
MULTI MERCHANT
SETUP
Select
option 5
for
RKI configuration
by pressing the corresponding number key.
5.0
RKI CONFIG?
ENTER OR CLEAR
Press
ENTER
to proceed with the RKI configuration or
CLEAR t
o cancel and exit to
idle screen
6.0
NII?
018
This parameter specifies the Network International Identifier that the terminal uses
to route messages to Paymark.
Press
ENTER.
7.0
RKI PHONE NO?
08797
This parameter specifies the Phone number of the Paymark Host, where it will be
connecting to download the keys. By default, the RKI phone number is set as
08797.
NOTE: If the merchant has the Toll Bar on the site, then key in this phone
number 1797 to obtain connectivity to Paymark network.
8.0
MULTI MERCHANT
SETUP
Terminal is now in configuration mode. Press
CANCEL
to exit, otherwise the
terminal will automatically exit after 30 seconds of inactivity
