INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - [email protected] – 07 19 AA 36 205 09
23
The UPS will
not turn on
The on/off Button is
designed to prevent
damage by rapidly turning
it off and on.
Turn the UPS off. Wait 10 seconds and then turn the
UPS on.
The unit is not connected
to an AC outlet.
The unit must be connected to a 220-240V 50/60Hz
outlet.
The battery is worn out.
Contact Technical Support.
Mechanical problem.
Outlets do not
provide power
to equipment
Circuit breaker is tripped
due to overload
Turn the UPS off and unplug at least one piece
connected equipment. Unplug the power cord of the
UPS then press the circuit breaker knob.
Batteries are discharged
Allow the unit to recharge for at least 4 hours.
Unit has been damaged by
a surge or spike.
Contact Technical Support.
Alarm
Alarm code
A06
Battery
capacityis low
Alarm code
A09
Battery
disconnected
Alarm code
A14
Over load occurs.
Alarm code
A16
EPO active
Alarm code
A18
Over
temperature
Fault
Fault code
F06
INV soft start fail
Restart the UPS,
if the fault is still, contact Technical
Support
Fault code
F07
INV volt high
Fault code
F08
INV Volt low
Fault code
F09
Output circuit short.
Your attached equipment may have problems, please
remove them and check again.
Fault code
F11
Battery voltage is too high.
1. Shut down the UPS
2. Check the counts of Battery
3. Check battery connector when use battery
packages.
Fault code
F12
Battery voltage is too low
Fault code
F13
Battery is
overcharge
Fault code
F14
Over load occurs.
Shut off non-essential equipment. If this solves the
overload problem, the UPS will transfer to normal
operation.
Fault code
F15
load unbalance
Fault code
F18
Fan has been damaged.
Shut down the UPS, Replace the fan