INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - [email protected] – 02 19 AA 59 203 27
13
User guide
To ensure this product is correctly installed and used appropriately, we highly advise you to
read this user guide very carefully.
1 . I N T R O D U C T I O N
Zen Live UPS provide safe and reliable uninterrupted power to multimedia devices and
tertiary computer equipment (computers, cash registers, inkjet printers, displays). Its
lightweight and compact design is ideal for working environments where space is limited.
Zen Live range is Auto-Regulated to provide balanced output power and offer complete
protection for your connected equipment in the event of power cuts or fluctuations. In the
event of a power failure, Zen Live provides power to the connected equipment up to 15
minutes (depending on the model and on the connected load), thus allowing continuity of
service or user intervention alerted by the UPS alarm. The main features of the Zen Live
range are given below.
2 . M A I N C H A R A C T E R I S T I C S
A highly-reliable microprocessor control
Automatic output voltage regulator (AVR)
Cold start feature if no power supply
Off-mode charging
Automatic restart during AC power recovery
Compact size, light weight
Wall mounting system
3 . S A F E T Y I N S T R U C T I O N S – S e c u r i t y
IMPORTANT!
Save this manual properly and read carefully the following instructions before installing the
UPS. Do not operate this UPS before reading through all safety information and operating
instructions carefully. Installation and Wiring must be performed in accordance with the
local electrical laws and regulations. Installing and connecting UPS system in a way that
does not comply with accepted practices releases Infosec Communication from any
liability.
Transportation
1. Please transport the UPS system only in the original package to protect against shock
and impact.
Preparation and good disposals of the device:
1. Condensation may occur if the UPS system is moved directly from cold to warm
environment. The UPS system must be absolutely dry before being installed. Please
allow at least two hours for the UPS system to acclimate the environment.
2. Do not install the UPS system near water or in moist environments.
3. Do not install the UPS system where it would be exposed to direct sunlight or near
heater.
4. Do not block air vents in the housing of UPS. The UPS must be installed in a location
with good ventilation. Ensure enough space on each side for ventilation.
5. The mains outlet that supplies the UPS must be located near the UPS and be easily
accessible.