Infortrend EonStor DS 4000 Series, Руководство по оборудованию

Страница: 59 / 90

EonStorDS 1000 Series
59
Installing Hard Drives into the Drawer (4U60 System)
Once the hard drive brackets have been installed onto hard drives that are to be
installed into the drawer, open the drawer 1 (situated on the left) insert each hard
drive vertically (in a specific order) while using bracket handle. Lower the hard drive
gently until you feel the connectors meet and firmly push it downwards to make full
connection. The bracket handle should clamp down onto the top of the hard drive.
When installing / adding hard drives, it is strongly recommended to install / add 12
hard drives into the designated locations shown below:
1
st
set ( in blue ) of 12 hard drive installation locations: 1, 6, 11, 16, 21, 26, 31, 36, 41,
46, 51, 56.
There are no restrictions on where or the number of hard drives must be
installed thereafter. However, it is recommended to install a set of 12 hard
drives ( in gray ) in-line / parallel to the initial set and so forth.
Back of enclosure