Infortrend EonStor CS 3016, Руководство по установке

Страница: 19 / 86

EonStor CS Installation Guide
page 19 / 86
Installation Guide
1-5. Node Status Checking

Connect the bundled power cords to the power sockets of the system (A).

Turn on the networking devices and the expansion systems.

Press the start button to turn on CS system (B).
You can observe the LEDs located at the front panel/power supplies at the rear of the enclosure/on drive
tray. Wait until all LEDs turn into normal status without red/amber lights (Please check LED status for each
part in the following section). If the LED color is still in red/amber for more than 3 minutes after powering
up, please check the following diagnostic guide.
Check LED status of front panel/power supply.
The following table shows the status of CS front panel LED, the system works normally with , ,
, and remain green light.
CS front panel LED