InfoPrint 6500-v05, Руководство пользователя

Страница: 165 / 340

Received DEL
v
Observe (the default). A DEL code received from the host is handled as a Delete
command.
v
Ignore. A DEL code received from the host is ignored.
Private Mode
Determines the default type of character set (Set 1 or Set 2). This can also be set by
ESC sequences ESC [>5h and ESC [>5l. Refer to these descriptions in the
ANSI
Programmer’s Reference Manual for further details.
v Set 2 (the default)
v
Set 1
Pos. on BC/OvrSz
v
Set to Top (the default). The paper is fed back to the top of barcodes or
oversized characters after they are printed. This allows printing on the same
line.
v
Set to Bottom . The printer will continue printing without backing up.
BC Check Digit
v
By Host (the default). The host calculates the barcode check digit and sends it
along with the barcode. The check digit is not verified by the printer but printed
as it was received.
v By Printer
. The barcode is sent without the check digit, and the printer
calculates and adds it in.
Barcode Darkmode
v
Enable (the default). The barcodes are printed at a higher resolution.
v
Disable. The barcodes are printed at lower resolution but at a higher speed.
PUM Default
This is the Unit of Measure (UOM) as it is used within the ANSI emulation.
Coordinates received in ESC sequences can be sent in two UOMs: Decipoints,
which is a unit of 1/720 inch, or in lines or columns using the current LPI and CPI
values. The UOM used is determined by this configuration setting.
v Decipoints
(the default)
v
Lines/Columns
Truncate PI Slew
v
Truncate at TOF (the default). The slew is terminated when the next Top-of-
Form is reached. (This function applies to the ANSI EVFU only).
v
Disable . PI slews will be completed independent of their length.
Chapter 4. The Configuration Menus
149