InfoPrint 6500 Series, Руководство пользователя

Страница: 110 / 360

110
Chapter 4
3270 Interface Menu
Override Host
Determines whether the printer executes certain commands sent by the host,
or continues to use the current settings. The following host commands are
ignored when OVERRIDE HOST is enabled: line length, forms length, lines
per inch (LPI), characters per inch (CPI), print quality, and text orientation (i.e.
left to right). When OVERRIDE HOST is enabled, these settings retain their
operator panel settings.
•
Disable (the default). Allows certain host commands (line length, forms
length, LPI, CPI, print quality, and text orientation) to override operator
panel settings. Note that the information appearing on the message
display may
not match the data stream setting. No values will change
upon initial selection of the disable option.
•
Enable . Permits operator panel settings to override host data stream
commands.
Format Control
Enables the printer to reflect the same spacing as 6408/6412 Model CT0
printers after absolute and relative move commands are executed. The
following options are available:
•
Disable (the default). Does not reflect distance, generated by the Code V
feature, IGP feature, and Hex Transparent control code sequence, in the
new position (after absolute and relative move commands are executed).
•
Enable . Reflects 6408/6412 Model CT0 distance, generated by the Code
V feature, IGP feature, and Hex Transparent control code sequence, in
the new position (after absolute and relative move commands are
executed).
C/T Hotport
Gives the printer the ability to handle multiple data streams simultaneously. It
allows the printer to serve hosts attached to the serial, parallel, and either
coax or twinax ports as if they were the only interface connected.
Port Type
Selects the type of port to be used. The Disable selection disables the port
from the hotport process. The available selections are:
•
Twinax (the default)
•
Coax
•
Disable
NOTE: Changing the Port Type in this menu option also changes the Port
Type setting in the Coax Interface Menu.