InfoPrint 6500 DBCS, Руководство пользователя, Страница: 68 / 230

68
Chapter 4
Configuration Management Menu
Protect Custom Sets
The PROTECT CUSTOM SETS option specifies whether or not a new
custom set can overwrite an existing custom set when you activate the SAVE
CURRENT VALUES parameter.
•
Disable (the default). Turns protection off, allowing you to overwrite
existing custom sets.
•
Enable . Turns protection on, preventing you from overwriting existing
custom sets. If you attempt to save to an existing set, the following
operator panel message appears:
043 CUSTOM SET ALREADY EXISTS
DELETE FIRST
You must delete the existing set before trying to save the new custom set.
Print Custom Set Values
This option is used to print a listing of various stored printer custom sets. It is
recommended that you store the printout of the custom sets in a safe place for
quick referral.
Config Key Default
This option configures the config key to print either the Quick setup menu or
the full config.
•
Quick Setup Config (the default). Prints the Quick setup configuration.
•
Complete Config . Prints the full configuration.
Name Custom Sets
You may specify a 39-character name which can be used to refer to a custom
set. The name you enter for a custom set will be used in the Recall Custom
Set, Save Current Values, Delete Custom Set, Change Power On Set, Protect
Custom Sets, Print Custom Set Values, and Name Custom Sets menus. The
name can only be cleared by using the Reset Custom Set Names menu.
Press the SCROLL/MICRO or SCROLL/MICRO keys to cycle through
the values available for that character at the cursor location. Press the
SCROLL/MICRO key to move to the next character to be modified. Press
the SCROLL/MICRO key to go back to a character you have already
modified. Continue until you have entered the name you want to give to this
custom set, then press
ENTER to save. The name you entered will now
represent this custom set on the printer's front panel. To exit this menu
without saving, press any key other than the
ENTER key. The custom set
name will revert to the last saved value.
Reset Custom Set Names
You can reset specific custom set names back to the default value of the
configuration number.