InFocus INF7012, Руководство по оборудованию

Страница: 12 / 36

Page 12
Connecting AC power
1) Connect one end of the AC power cord to the AC In jack on the back of the display.
2) Connect the other end of the AC power cord to an AC outlet.
3) Press the power switch. (The LED on the front of the display turns on.)
NOTES:
• Your display should only be operated from the power source indicated on the label.
• Always unplug the AC power cord from the power outlet when you are not using your display for an extended period of time.
External PC touchscreen control setup
1) Connect an external computer to the display using a DisplayPort, HDMI, or VGA cable.
2) Connect the Type A to Type B USB cable to the USB Type A jack on the computer and to the USB Type B jack on the side of the
display.
3) The computer can now be controlled by using touchscreen gestures on the display.
TURNING THE DISPLAY ON/OFF
1) Verify that the power cord is connected to a power outlet and that the power switch is ON .
2) Press the Power button on the remote or the right side of the display. (The LED on the front of the display
turns off.)
NOTES:
• If the display does not respond to normal power down procedures, press and hold the PC box Power button (located on the back of
the display) for 7-8 seconds.
• By default, the display goes into system standby after 20 minutes of inactivity. To change this behavior, use the Daytime Power
Management feature within the Mondopad software or make power option changes within the Windows Control panel.