6. Check each tweeter’s placement with the listening
position (e.g., on-axis placement provides the best per-
formance). If necessary, loosen the nut, rotate the
assembly and adjust the tweeter’s angle, and retighten
the nut.
7. Connect tweeter wires to the appropriate connection
points and re-install each panel.
F
LUSH
-M
OUNT
I
NSTALLATION
Refer to Figure 7 (below) for correct orientation of the
flush-mount kit. When removing panels at a selected site,
make sure there is minimum mounting depth of 44.5 mm
(1
3
⁄
4
") behind each panel.
1. At each chosen site, remove the panel and use the
flush-mount cup (or flush-mounting template) as a
guide to cut a hole for tweeter mounting.
2. Route the tweeter’s pigtail wire through each base and
carefully press each tweeter in until it snaps into place.
3. Insert each tweeter (and base) into a flush-mount cup
and route the tweeter’s (pigtail) wires through the
opening in the cup.
4. Place each entire assembly into a panel opening so the
cup lip is flush against the panel.
5. Route each set of tweeter wires through the cup’s nut
and hand-tighten each nut against back of the panel.
R
EFERENCE
6513
CS
A
UTOMOTIVE
C
OMPONENT
S
PEAKER
S
YSTEM
CAR AUDIO
Figure 7. After the Reference 6513cs tweeter
is in its cup, hand-tighten the nut to flush-
mount the assembly on the panel.
A
DJUSTING
T
HE
S
OUND
Initially connect the + leads (on the satellite crossover
connections) to the following terminals: woofer to HI,
midrange to HI, and tweeter to MID.
Once the wiring has been completed, turn on the system
and begin playing a high-quality CD or tape with a wide
musical range. Set the controls on your source unit, equal-
izer, etc. to their normal listening positions and listen to
the sound of your Reference 6513cs system.
Experiment with several different setting combinations as
you listen to a wide variety of music under different dri-
ving conditions. This will help you reach the optimum
sound balance and greatly enhance your listening enjoy-
ment. Remember to turn off the system each time you
make any changes. For increased tweeter level, move the
t leads to HI terminals. For decreased tweeter
level, move them to LO.
S
PECIFICATIONS
System Power Handling:
125 watts
System Sensitivity:
90 dB
Frequency Response:
60 Hz ~ 20 kHz
Infinity constantly strives to update and improve existing products, as well as
create new ones. Therefore, the specifications and construction details in this and
related Infinity publications are subject to change without notice.
© Infinity Systems, Inc. 1997 P/N 939-8089
Ref 6513cs Manual 7/14/98 10:45 AM Page 8
