T
WEETER
I
NSTALLATION
Reference 6513cs tweeters are easy to install. Each is
housed in a surface-mount enclosure with grille and is
equipped with an attached color- and terminal-keyed wire
pigtail. For custom installations, each tweeter includes a
flush-mount kit that features an adjustable firing angle.
S
URFACE
-M
OUNT
I
NSTALLATION
Refer to Figure 6 (above) for correct orientation of the sur-
face-mounting plate. A 7.9 mm (
5
⁄
16
") diameter hole is
required to pass tweeter wires and pre-attached termi-
nals. Make sure each proposed hole will not extend beyond
the boundary of the tweeter enclosure.
1. At each chosen site, use the mounting plate (or mount-
ing template) to mark locations of mounting holes and
a feed-through hole for speaker wires.
2. Drill 3.2 mm (
1
⁄
8
") holes for mounting screws.
3. Drill 7.9 mm (
5
⁄
16
") holes to create passages for wires.
O
WNER
’
S
M
ANUAL
A
ND
I
NSTALLATION
G
UIDE
7
Figure 5. Installing a Reference 6513cs woofer in a deck.
4. Fasten each mounting plate to its site with supplied
#8 x 19 mm (
3
⁄
4
") screws.
5. Route the tweeter’s pigtail wire through each feed-
through hole and attach it to the yellow terminal-
keyed wires from the crossover and make the connec-
tions at each pigtail end.
6. Push the wires into the opening and carefully press
each tweeter onto the mounting plate until it snaps
into place.
...continued on next page
Figure 6. After installing the surface-mount plate, push the
Reference 6513cs tweeter onto the mounting plate to snap it
into place.
Ref 6513cs Manual 7/14/98 10:45 AM Page 7
