CHARGING
1. Fully charge battery for up to 2.5 hours before first use either
attached or detached from the device.
2. To charge, connect DC end of the supplied 24V adapter to the
battery’s charging port and plug AC side cable into wall outlet.
3. In Standby mode, the LED lights on the device control panel flash
regularly, indicating the battery level and that it is charging. The ring
on the bottom of the battery pack also flashes and changes color to
indicate battery charge. If the battery switch on the bottom of the
battery pack is Off, only the battery pack ring will flash from yellow to
green, when battery is fully charged, battery ring will stop flashing
and stays on green.
4. Battery may be recharged at any time and at any battery level.
Do
not use this device while charging.
5. One flashing light indicates low power and the battery needs to be
recharged.
REMOVING BATTERY PACK
1. To remove the battery pack from the device, press in the battery pack
release button located on the side of the device and twist back and
forth while firmly pulling down on the battery pack until it comes out.
2. To re-attach the battery pack, align the groove key on the side of the
battery pack with the groove on the inside of the battery pack slot.
Push the battery up firmly into the device until you hear a click sound.
OPERATION
1. Make sure battery switch on the bottom of the battery pack is turned
on and the battery pack ring is lit indicating that the device is in
standby mode. If the ring is not lit, switch off and then on again.
2. Press the power button on the control panel to turn device on.
3. Device will start at speed level 1. To cycle through the 5 different
speed levels press the power button. When the device is at speed
level 5, press the power button once more to enter standby mode
(speed level 0). To restart, wait 3 seconds and then press the power
button to enter speed level 1 again.
4. At any time after turning on the device, long press the power button
to enter standby mode.
5. To completely turn off, slide the battery switch to off.
6. If the device is left idle in standby mode for 60 minutes it will
automatically turn off.
6
5
Battery pack button
Battery Pack
Twist back and forth
while pulling down.
