INTERMOUNT III MOUNTING RINGS
The Kappa 60.7cs is packaged with two different
speaker adaptor rings. The rings will allow the
speakers to be installed into various factory 6,"
6-1/2" and 6-3/4" openings. The metal ring can be
mounted in many European vehicles, Japanese
vehicles or vehicles with 6" speaker locations. The
plastic ring can be mounted in many vehicles
using 6-3/4" speaker locations or three-point
mounting frames.
Figure 3.
Mounting the 65.7cs in a 165mm
speaker location using the supplied metal ring.
Figure 4.
Mounting the 60.7cs woofer in a standard
speaker location.
FLUSH-MOUNT
Figure 5A.
Mounting the tweeter using the
I-Mount™ flush-mounting kit.
SURFACE-MOUNT
Figure 5B.
Mounting the tweeter using the
I-Mount surface-mounting cup.
2
3
(—) SMALL LUG
(+) LARGE LUG
BLACK
RED
RED (+)
RED (+)
BLACK (—)
BLACK (—)
1
ATTACH BASE
WITH SCREWS, THEN:
1
2
3
kappa series
I
NSTALLATION
FOAM GASKET
MOUNTING RING
FOAM GASKET
TWEETER ANGLE
Figure 6.
Aim the tweeter at the listening position
by sliding the stud in the groove on the back of
the tweeter cup and rotating the entire assembly
in the mounting surface. Lock the tweeter in
place, using the small retaining screw.
Figures 7A through 7D.
The Starfish™ tweeter
mount is intended to be used when the tweeter
will be installed behind a factory grille (e.g.,
replacing the factory tweeter behind a door
panel). The Starfish will allow you to mount the
component tweeter directly to the panel itself or
to the area behind the panel. The six mounting
tabs can be removed easily to create a number
of custom configurations.
Note: Check screw clearance before installing.
Use glue if clearance is an issue.
Note: Not all possible mounting configurations
are shown.
1
SLIDE SCREW UP OR
DOWN TO ADJUST
TWEETER ANGLE.
4
SECURELY TIGHTEN
THE LARGE HAND NUT.
2
TIGHTEN SCREW TO
LOCK ANGLE SETTINGS.
3
ROTATE ENTIRE ASSEMBLY
TO AIM ANGLED TWEETER
TOWARD LISTENER.
Figure 7A.
Behind grille panel.
Figure 7B.
Mounted to surface behind grille panel.
Figure 7C.
Mounted to grille panel.
Figure 7D.
In-dash location (may require gluing).
