Infinity 41527, Руководство пользователя

Страница: 16 / 48

15
Ordercode: 41527
Infinity iW-1240 RDM
Control Panel
A)
B)
C)
D)
E)
F)
G)
H)
I)
J)
K)
Home button
Edit Menu button
Settings Mode button
Address Setting button
Infinity Logo button/Previous screen
Up button
Down button
OK/ENTER
Left button
Right button
LCD display
Fig. 08
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the Infinity will respond to the controller.
Please note when you use the controller, the unit has 63 channels.
When using multiple Infinitys, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Infinity should be 1(001); the DMX address of the second Infinity
should be 1+63=64 (064); the DMX address of the third Infinity should be 64+63=127 (127), etc.
Please, be sure that you do not have any overlapping channels in order to control each Infinity correctly.
If two or more Infinitys are addressed similarly, they will work similarly.
For address settings, please refer to the instructions under ”Addressing”.
Controlling:
After having addressed all Infinity fixtures, you may now start operating these via your lighting controller.
Note: After switching on, the Infinity will automatically detect whether DMX 512 data is received or not. If
not the problem may be:
●
The XLR cable from the controller is not connected with the input of the Infinity.
● The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 40 seconds
When no button is pressed for 40 seconds, the display will turn off.
To light up the display, you have to press any of the buttons on the control panel.
Once you have pressed the button, the display will light up.