InfiniSource ETC 100, Руководство по оборудованию

Страница: 29 / 234

TimeForce II Hardware Guide 17
ETC 100 Model Clock
ETC 100 Model Clock
ETC Model clocks are available with the following communication
options, Serial, Serial Daisy and Modem. Each clock model is explained
in detail in this chapter.
Creating a Time Clock Profile
Before the ClockLink utility will be able to connect to your time clock,
you must first create a profile for the clock within the TimeForce pro-
gram. Clock profiles are created from the main “Clocks” section of the
TimeForce software.
1. Open the TimeForce software and log in as a user with administra-
tive rights.
2. Click on the main “Clocks” navigation tab at the top of the screen.
3. To create a new clock profile, click on the [ADD CLOCK] icon
located under the
New Clocks header on the left-hand side of the
screen.
4. Select “ETC” from the Model drop-down menu.
5. The clock Number is also known as the Clock ID. This number is
assigned in the memory of the clock itself. The default number is
“1.”
6. Enter the clock Password . This password is also assigned in the
memory of the time clock. The default password is “ETC.”
7. If you would like to restrict it so that only a specific range of card
numbers will be accepted at the time clock, enter the desired range
into the
Card Range fields.
8. Enter a Description for this clock as you would like it to appear in
TimeForce II and ClockLink.
9. If you would like to assign this clock to a group, make the desired
selection from the
Clock Group drop-down menu.
Note: See page 211 for instructions on creating clock groups.