InfiniSource ETC 100, Руководство по оборудованию

Страница: 141 / 234

TimeForce II Hardware Guide 129
Velocity Clocks
• Cellular: Put a check mark in the DHCP option to use
Dynamic Host Configuration Protocol. Otherwise, enter the IP
Address where the clock can be reached. Remember to use
periods. If the clock can only be reached using a specific port
number, enter the appropriate port into the
Port Number field.
Leave this field blank to use the default port.
Note: These settings are specific to your network setup. Infini-
source cannot supply these settings.
17. Before you can customize the information to be sent to the clock
from TimeForce II, you must first add the clock profile to the sys-
tem. Click on the [CREATE] icon located in the lower left-hand
section of the screen.
Customizing Time Clock Information
Multiple levels of information can be uploaded to the time clock from
the TimeForce database.
Allowed Period
This is the period of time during which the time clock will accept
punches. Any employee punching outside of this time range will receive
an error message stating that supervisor approval is required in order to
complete this punch. The punch will only be recorded if a supervisor
user enters their administrator password and “clears” the punch.
Note: Default Allowed Periods are only used when employee schedules
are not uploaded to the clock. When schedules are being used, the time
range specified in the Schedule Template that the employee's schedule is
assigned to is used as the employee's allowed period.
Default Allowed Periods are specified within each clock's time clock
profile in the TimeForce II system. Use the following instructions to
customize allowed periods.
1. Open the TimeForce II software and log in as an administrator-level
user.
2. Click on the main “Clocks” navigation tab at the top of the screen.
3. From the Existing Clocks section of the screen, click on the [EDIT/
VIEW] icon.