112
Infinisource
Hardware Installation
The clock should be placed in a convenient location where employees
typically enter and exit the work area. It includes a mounting plate with
four holes. Mounting screws are included. Once the mounting plate is
attached to the wall and all cables are connected, the clock’s face can be
slid into place and secured to the mounting plate.
1.
Attach the clock mounting plate to the wall with the provided
mounting screws.
2.
Connect the power cord to the bottom of the time clock and plug it
into the closest electrical (110 - 120 VAC) outlet.
3.
Connect the RJ-11 connector of the cable (the one that looks like a
phone-jack) into the right side port on the bottom center of the
clock.
4.
Connect the 9-pin serial connector end of the communications
cable to the “SERIAL” port.
5.
The clock is shipped with the SIM card pre-installed. No SIM con-
figuration is required.
6.
The clock can now be attached to the mounting plate. Place the top
of the clock on the lip at the top of the mounting plate. Slide the
clock over the center tab on the bottom of the clock until the center
screw hole at the bottom of the clock aligns with the screw hole in
the tab. Secure the clock by placing a screw through the aligned
hole.
Содержание ETC 100
