InfiNet Wireless Quanta 5, Техническое руководство пользователя

Страница: 97 / 100

Quanta 5
Quanta 5 Technical User Manual
97
8.5.2 Restore to the factory default settings
In case you need to restore your unit to the factory default settings, proceed as follows.
NOTE
If the management of the unit is lost due to unknown user name or password it can be restored
using factory password. Enter the device serial number to the "Login" field and factory
password - to the "Password" field.
Obtain the factory password. In order to do this, please contact the distributor through
whom the unit was purchased, or in case purchasing the unit directly in InfiNet Wireless,
send a request to the InfiNet Wireless support team. The request must include the unit
serial number and the value of "Sequence" field (if it's non-zero).
Obtain the unit IP address using the ERConsole as described in the section above.
Click on the "+" button in the ERConsole application and a new window will appear.
Select "Reset configuration" option and enter the factory password to the "Factory
password" field, then click "OK". The password must be entered at the same format as it
has been got from the distributor or IW support team (with the gaps).
Turn off and on the unit and then wait for about 30 seconds.
The unit will start in a special emergency mode with the IP address 10.10.10.1 and mask
255.255.255.0.
Login to the unit and use "Restore factory settings" button on the "Maintenance" section
to switch off emergency mode.
Set new login and password, then save the configuration and restart the unit.