XC164CM
XC164CM Board
Quick Start Up
XC164CM series Board Manual
23
V 1.0, 2006-01
5.7
Connect to the Target
Make sure that the Starter Kit board is connected to your PC as well as to your power
supply. Hit the reset key on the starter kit. Now press the 'connect' button in Memtool.
If the software status bar displays 'Ready for Memtool Command' you successfully
installed Memtool.
Figure 14
Successful connection
5.8
Prepare Memtool for programming
Check the setup for programming, select “Automatic Erase before Program” and
Automatic Verify after Program
Open the compiled hex file (*.hex / *.h86) from the project directory and push the “Select
All” and “Add Sel.>>” Buttons
Figure 15
Setup for programming
