User Manual
5
V1.0
2021-04-28
Small Engine Management Evaluation Board
User Manual for TLTLE8080EM Evaluation Board
1.1.2
Connector Interface for Arduino
The Connector placement of the Evaluation PCB is compliant with the Arduino form-factor. The pinouts are
listed below.
Figure 5
Power Connector J502
Table 3
Power supply Connector J502
Pin no. Arudino Signal Name
Evaluation PCB Signal Name
Description
1
-
-
-
2
IOREF
VIO
Communication supply level (SPI)
3
RESET
RESET#
External reset signal (low active)
connected to NRIO. Reset of TLE8082ES
and TLE8080EM (if R27 jumper
assembled).
4
3.3V
+3.3V
3V3 volt supply – not used
5
5V
+5V
5V volt supply – not used
6
GND
GND
Ground
7
GND
GND
Ground
8
VIN
VBAT
Voltage Level (usually 12V) applied to
VS and KEY (if J1 is closed)