Infineon DCDC SBC Series, Начало работы

Страница: 5 / 17

TLE9273QX Evaluation Board
Getting Started
TLE9273QXEvaluation Board 5 Rev 1.0, Dec 2018
3.
Buttons
In the upper right corner there are three buttons.

Test Button for enabling test mode (press during SBC Init-Mode when sending arbitrary SPI command)

Reset Force this button is connected in parallel to RO output of SBC and will connect RO line to GND
when pressing to force a low signal on RO

Wake this buttons will do a voltage transition on the wake input of SBC to trigger an external wake
4.
LEDs
In the upper left corner are 3 LEDs to indicate the state of the Fail-Outputs. The LEDs can be disconnected
via the jumper directly under the LEDs. There are also two indication LEDs for the status of VCC1 and VCC2
(see behind the banana sockets for VCC1 and VCC2) which can be also disconnected via the jumpers directly
next to the banana connectors of VCC1 and VCC2
5.
Connectors
5.1. uIO Connector
The uIO Connector is used for connecting to the uIO stick, but can be also used to access the uC
interfacing pins. The pin distribution of the connector is shown in the following figure:
Pin Functionality Pin Functionality
1 NC 2 GND
3 NC 4 NC
5 NC 6 VS_UIO
7 NC 8 INTN
9 CSN 10 NC
11 CLK 12 FO_UC
13 SDO 14 RSTN
15 SDI 16 ADC_UIO