PSoC 4 Down Counter 7-bit
Document No. 002-24891 Rev.**
3
Figure 3. switch_pin Parameter Settings
For information on the hardware resources used by a Component, see the Component datasheet.
Reusing this Example
This example is designed for the CY8CKIT-042 pioneer kit. To port the design to a different PSoC 4 device and/or kit, change
the target device using the Device Selector and update the pin assignments in the Design Wide Resources Pins settings as
needed.
Table 2
shows pin assignments required for UART operation on other PSoC 4 devices.
Note:
This project cannot be built for PSoC 4 devices with no UDBs.
Table 2. Pin Assignments for Different Kits
Pin Name
Development Kit
CY8CKIT-042
CY8CKIT-042-BLE
CY8CKIT-044
CY8CKIT-046
\UART:rx\
P0[4]
P1[4]
P7[0]
P3[0]
\UART:tx\
P0[5]
P1[5]
P7[1]
P3[1]
In some cases, a resource used by a code example (for example, an IP block) is not supported on another device. In that case
the example will not work. If you build the code targeted at such a device, you will get errors. See the device datasheet for
information on what a device supports.
