4.11.2
Global preferences
In the
Global
tab, the following preferences can be edited:
•
Small Icons in Legend
: Shows small or large icons in the legend.
•
Automatically Check for Updates
: Checks every week if a new version of Inertia Studio
is available.
•
Store Sensor Settings Automatically
: Automatically stores the sensor settings perma-
nently on the node(s), 15 seconds after applying.
•
Automatically Open Export Window
: Open the
Export Logfiles
window (see Section 4.6
when an Export starts.
•
Show Network Adapters
: Shows the network adapters that can be used to connect to
an Advanced Inertia Gateway via Ethernet.
•
Down Sampling
: A number of samples can be averaged before showing them in the
plot. This improves performance, but shows a flattened signal. Down sampling cannot
be applied to FFT plots and has no effect on the values in the log files.
•
Sample Loss Interval (s)
: Sets the interval in seconds used for the accumulation of lost
samples and calculation of the sample loss percentage, shown in the legend.
•
Plot History (s)
: Sets the maximum number of seconds of data to show in the plot (visible
when panning the plot).
•
Register File Extensions
: Registers the
itlog
and
fwu
(firmware update file) file exten-
sions to Inertia Studio.
Figure 37: Global Preferences
Page 46 of 60
