ORS-X1T
SINGLE CHANNEL RADIO RECEIVER WITH DECODER
for shutter, rolling door and grille drives.
Operation and installation manual
Safety notes
Basic notes
The ORS-X1T control unit is supplied in a condition allowing for safe operation and use, provided that all the guidelines
contained in this operation manual and applicable to the given use (e.g. gate or shutter), as well as current safety and accident
prevention regulations are observed.
The electrical components of the product may only be installed and repaired by qualified and licensed technicians.
Any modifications or changes to the product are not allowed. Warranty repairs may only be carried out by the manufacturer.
Only genuine spare parts and accessories may be used for post-warranty repairs.
The operating safety of ORS-X1T unit is guaranteed provided it is used according to the manufacturer's specification. The
limit values specified in the technical specification must be strictly observed.
Additional safety regulations
All important safety regulations and rules for preventing accidents applicable to the given application (e.g. gate or shutter)
must be adhered to when installing, starting up and maintaining the control unit. The following regulations are to be taken
into account in particular:
1. Fire safety regulations.
2. Accident prevention regulations.
GENERAL HAZARD AND SAFETY NOTES
The notes provided herein are general guidelines for using INEL control units in conjunction with other equipment. These
guidelines are to be strictly observed when installing and operating the equipment.
Warning - a warning note on potential damage to the control unit or other assets
in case of failure to adopt proper means of safety.
Danger - indicates an existing danger to life and health of the user in case
of failure to apply appropriate means
of safety.
Check that all screw connections are tight prior to installing the unit and setting the limit switches.
Observe safety and accident prevention regulations applicable to the given use (e.g. shutter, gate).
Before replacing fuses, unplug all power supply cables, then replace the fuse and reconnect the power cables.
The ORS-X1T unit must be installed with adequate protections and protective devices required by applicable
regulations. The control units featuring crushing protection with a sensor installed on the gate, which the protection
acts upon contact of foreign body with the gate, must not cause any injuries caused from the movement of the gate.
For INEL equipment with constant mains input to the unit, a switch ensuring safe voltage interruption (e.g. fuse-
switch), must be used apart from the safety fuse, installed in such way that all the connections can be easily
disconnected.
Regularly inspect all cords and cables for damage to insulation and local breaks.
In case of identifying cord damage, immediately disconnect the damaged cables from the mains and replace the
damaged cords.
Before connecting the product to the mains it must be confirmed that its rated voltage conforms to the local mains
voltage.
CAUTION - IMPORTANT TO HUMAN SAFETY:
do not allow children to play with the control unit;
keep remote control devices out of children's reach;
observe the moving system (e.g. gate, awning) and keep any bystanders away until full shutting or opening;
all users of the gate must be trained or instructed on the principles of its operation and the related operating
hazards. Persons may be deemed as duly trained if the employer, administrator or owner has permitted them to
open the gate, and instructed them on how to use it.
