Industrial Scientific RGX Series, Руководство по эксплуатации продукта

Страница: 31 / 62

21
There are two methods for accessing the RGX Configuration Interface — through a wi-fi or Ethernet
connection. Supplies required for each access method are listed below.
Table 3.3 Supplies needed for configuration
Access method
Item Wi-fi Ethernet
Torx screwdriver with a T25 bit No Yes
Ethernet cable Cat5 or greater No Yes
Computer (with browser) No Yes
Smart device (with browser) Yes (or computer) No
RGX Serial Number (S/N) Yes Yes
Access to iNet Yes Yes
When using the RGX Configuration Interface, the following apply.
•
If you are not familiar with your company's communication protocols, see your network administrator for
assistance.*
•
If your company’s wireless network uses “WPA2 - Enterprise” security , the RGX Interface will require the
upload of a certificate of authenticity that is 2048-bit or less and supplies the full chain of trust.*
•
As with most applications, the Interface is subject to timing out when idle.
•
When a data field appears in gray, no entry is required.
•
Within each section, work from top to bottom.
•
When a "test" button appears, use it after entering all the required values that precede it; then, follow
any on-screen instruction to learn of and correct for any invalid or missing values.
* These items do not apply to an RGX Gateway operating in LENS repeater mode.
Based on your access method, wi-fi or Ethernet, complete only one of two possible instruction sets as
indicated below.
Table 3.4 RGX Configuration Interface instruction sets by access method
Instruction set
Figure 3.3 Figure 3.4
Access Method
Wi-fi Yes No
Ethernet No Yes