Indu-Sol PROmesh P9+, Руководство пользователя, Страница: 46 / 49

Web application
PROmesh P9+
– User Manual
46
Important:
Do not perform the following actions while the firmware update is in progress.

Do not disconnect the device from the power supply voltage under any circumstances.

Do not pull or change any network connectors.
A message will tell you when the update is complete. The device will restart automatically at that point.
Factory settings
This menu item is used to reset the device to its factory settings.
Cl
ick the “Reset to default” button for this and confirm it in the window that opens. The device must then be
rebooted.
Reboot
You can restart the switch to perform a software reset here. Pressing the reboot button will exit the switch
software and reboot the device.
You can also turn both power supply voltages of the switch off and on again to perform a hardware reset.
3.11 Support
The support section contains all relevant contact information for Indu-Sol
License information
The linked license.txt file contai
ns information regarding the “Open Source Software” used.
3.12 Troubleshooting advice

Check that the power supply is correct. At least one of the VDC LEDs must light up green.

Check the link/act LEDs of the wired RJ45 sockets. The link LEDs must light up when a connection
is established and flash when data is being transmitted.

If in doubt, disconnect redundant network structures and reset the PROmesh P9+ switch to factory
settings. Make your settings again bit by bit and observe where the error occurs if the
communication works afterwards.