Indian Motorcycle SCOUT BOBBER 2021, Руководство пользователя

Страница: 47 / 162

ITEM INSPECTION PROCEDURE
Front
Suspension Check for leaks, debris and damage.
Steering Check for smooth operation by turning handlebars full left
and full right.
Rear
Suspension Check mounting and inspect for leaks.
Rear Drive
Belt Check for wear or damage. See page 80 and page 80.
Sidestand Verify smooth operation, inspect pivot bolt and spring.
Fasteners Inspect for loose, damaged or missing fasteners.
Mirrors Adjust for proper rear view.
EENNGGIINNEE OOIILL LLEEVVEELL
With the semi-dry sump lubrication system, the engine oil level on
the dipstick will fluctuate, depending on the motorcycle’s position
and engine temperature when checked. To ensure a proper
reading of the engine oil level, follow all inspection procedures
closely.
WARNING
Operating with insufficient, deteriorated or contaminated engine
oil will cause accelerated wear and may result in engine or
transmission seizure, which could result in loss of control and
serious injury or death. Check the oil level frequently.
Always check the oil after running a cold engine at idle for 30
seconds. The oil fill/dipstick is located on the right side of the
motorcycle. Always use the recommended oil. See page 139.
1. Position the motorcycle on level ground in the fully upright and
centered position.
2. Start the engine (from cold) and allow it to idle for 30 seconds.
Stop the engine.
3. Remove the dipstick
q
and wipe it clean.
4. Thread the dipstick until fully seated.
45
PRE-RIDE INSPECTIONS