10
Product note
W9800029EN-02.02.18
Base holder for boring slide
10
9
8
910
10
9
8
13
13
9
10
12
10
9
9
10
10
9
9
10
12
5
5
2
1
5
5
2
1
11
11
Setup on boring slide
Conversion Z orientation, 30 mm offset
• Loosen mounting screws (5)
on the boring slide (13)
• Remove base holders (1+2)
• Loosen and remove mounting
screws (9) for stop (8)
• Remove stop (8)
• Remove set screws (10)
• Loosen clamp (12) for adjusting screw (11)
• Turn stop (8) 180° around the short side
• Install set screws (10)
• Position stop (8) on contact surface
• Insert mounting screws (9) for stop (8) on boring slide (13)
• Turn in set screws (10) until stop (8) sits tight
• Tighten mounting screws (9)
• Attach base holders (1+2) with mounting screws (5) at 30 mm offset
• Realign if necessary