GB
21
*
Only available in certain models.
If the appliance is fitted with an electronic lighting device*
(see figure), simply press the OVEN control knob and turn
it in an anticlockwise direction, towards the MAX position,
until the burner is lit. If, after 15 seconds, the burner is
still not alight, release the knob, open the oven door and
wait for at least 1 minute before trying to light it again. If
there is no electricity the burner may be lit using a flame
or a lighter, as described above.
!
The oven is fitted with a safety device and it is therefore
necessary to hold the OVEN control knob down for
approximately 6 seconds.
!
If the flame is accidentally extinguished, switch off the
burner and wait for at least 1 minute before attempting
to relight the oven.
Adjusting the temperature
To set the desired cooking temperature, turn the OVEN
control knob in an anticlockwise direction. Temperatures
are displayed on the control panel and may vary between
MIN (150°C) and MAX (250°C). Once the set temperature
has been reached, the oven will keep it constant by using
its thermostat.
Grill
By turning the OVEN control knob in a clockwise direction
until it reaches the
position, the infrared ray grill is
activated. The grill enables the surface of food to be
browned evenly and is particularly suitable for roast
dishes, schnitzel and sausages. Place the rack in position
4 or 5 and the dripping pan in position 1 to collect fat and
prevent the formation of smoke.
!
The GRILL indicator light shows when the grill is
operating.
!
Always use the grill with the oven door shut; this achieves
better cooking results and saves energy (approximately
10%).
Oven light*
The light may be switched on at any moment by pressing
the OVEN LIGHT button.
Timer*
To activate the Timer proceed as follows:
1. Turn the TIMER knob in a clockwise direction
for
almost one complete revolution to set the buzzer.
2. Turn the TIMER knob in an anticlockwise direction
to set the desired length of time.
WARNING! The oven is provided
with a stop system to extract the
racks and prevent them from
coming out of the oven.(1)
As shown in the drawing, to
extract them completely, simply
lift the racks, holding them on the
front part, and pull (2).
Turnspit*
To operate the rotisserie
(
see diagram
) proceed as
follows:
1. Place the dripping pan
in position 1.
2. Place the rotisserie
support in position 4 and
insert the spit in the hole
provided on the back
panel of the oven.
3. Acitvate the function by pressing the TURNSPIT button.
