Golden Tee
®
Home Edition
Page 10
© Copyright 2020 Incredible Technologies, Inc. All Rights Reserved. Unauthorized duplication is a violation of applicable law.
All other marks are the properties of their respective owners. All rights reserved. PN 815000356RB
I/O Board Removal
First, unlock the control panel and open to expose the interior of the Showpiece cabinet. Disconnect all
connections from the I/O Board. Label the connectors for easy reconnection and move them safely out of the
way. Next, remove the six ¼” wood screws that secure the board to the interior left side of the cabinet (as you
face the game). Carefully remove the I/O Board from the cabinet.
I/O Board Installation
Place the I/O Board in the proper location on the interior left side of the cabinet (as you face the control panel of
the game). Be sure it is oriented properly so the cables reach the board (the USB port on the I/O Board facing the
top of the cabinet). Secure the I/O Board to the side of the cabinet with the six ¼” wood screws. Use the factory
mounting holes if at all possible. Be sure the board does not
“bow” or is not stressed in any way. Once mounted,
connect the appropriate connections.
Keypad
Newer IT cabinets have the ability to register players through a keypad box attached at the back or to the side of
the cabinet. For details on installing the Keypad, see the Keypad Installation Guide under Golden Tee LIVE
on the IT web site:
http://amusement.itsgames.com/service/manuals
Cabinet Identification Device (CID)
This device contains a specific ID number that identifies your cabinet. The CID is a permanent number and must
be connected to the main system box via the USB cable and working properly in order for the game to operate.
CID Removal and Replacement
If for some reason you must replace the CID, disconnect the USB cable from the CID. This is the only connection
to the CID. Next, remove the four ¼” wood screws that secure the CID to the interior left side of the cabinet (as
you face the game). The CID is located above the I/O Board. To install a CID, mount the CID in the proper
location using four ¼” wood screws. The CID should be mounted so the USB port is facing the top of the cabinet
and the electronics are facing the wall.
Lock
The lock on the rear of the Showpiece cabinet allows access to the Nighthawk system box under the control
panel.
Service Button
Mounted under the outer edge of the Showpiece cabinet are controls for System Setup. Reach under the rounded
ledge on the front right side of the cabinet and press the red button to access the
game’s System Setup software
menu system. The System Setup menus cover a variety of important areas including tests, game adjustments,
and optional settings.
CONTROL PANEL
Opening the control panel provides access to all game controls and hardware components. To open the control
panel, simply use the supplied key in the lock on the back of the cabinet and lift from the back. The control panel
is hinged in front and will stay open when fully extended.
Soft Power Switch
A “soft power” switch has been added to the underside of the control panel, to assist in the update process. This
switch will turn off power to the
cabinet so you don’t have to reach around to the main power switch located on the
back of the cabinet.
Note:
The Cabinet Identification Device should
NEVER
be removed from the cabinet, even when replacing any of the other
components. The CID is the cabinet’s PERMANENT Identifier, regardless of any other components.
Note:
If you turn power off using the Soft Power Switch, you
must
use this same switch when turning power back on.
Содержание Golden Tee Home Edition
Страница 1: ...Rev 10 2020 ...
