2
Remove the hex bolt that secures the protractor head
and replace with the large threaded knob included in the
hardware pack. The washer on the hex bolt must be
used with the threaded knob, Fig. 1.
FIG. 1
Assembly
Squaring the fence to
your table saw top
The method used to join the fence mounting bracket to
the protractor head makes it easy to fine-tune the fence
perfectly perpendicular to your tabletop. To adjust,
loosen the (3) #10-24 socket head screws that secure
the bracket and slide a paper or plastic shim between
the bracket and the protractor head. Placing the shim
behind the screws will decrease the angle. Placing the
shim in front of the screws will increase the angle.
Place the INCRA Miter3000 in the left-hand miter slot
of your table saw. Loosen the (2)
1
⁄
4
-20 socket head
screws that secure the fence to the fence mounting
bracket and slide the fence to a position that leaves safe
clearance between the end of the fence and the blade. Tighten
the (2)
1
⁄
4
-20 fasteners, Fig. 3.
If the miter slot in your table saw has a T-slot, attach the T-clip to
the end of the miter bar as shown in Fig. 2.
FIG. 2
FIG. 3
1
2
Threaded
knob
1/4-20 socket head
screws
Position fence for safe clearance
between fence and blade
Miter bar
#10-24 x 1/4"
phillips flat
head screw
T-clip
Remove
hex bolt
Washer
Placing shim
in back of
screws will
decrease
the angle
