I N T E L L I G E N T C O N T R O L S I N C
h t t p : / / w w w . i n t e l c o n . c o m
7 4 I N D U S T R I A L P A R K R D S A C O M E 0 4 0 7 2
U
S
A
Replacement Parts Instructions
0000231A.DOC
E - m a i l :
t e c h
@ i n t e l c o n . c o m
F A X 1 - 2 0 7 - 2 8 2 - 9 0 0 2
T E L 1 - 8 0 0 - 9 8 4 - 6 2 6 6
P A G E
1 o f 1
s a l e s
@ i n t e l c o n . c o m
F A X 1 - 2 0 7 - 2 8 3 - 0 1 5 8 T E L 1 - 8 0 0 - 8 7 2 - 3 4 5 5
DANGER Electrical shock hazards!
Turn off and lock-out the submersible
pump power source (terminated at
L1 and L2), and the pump relay power
source (terminated at S2, from the
dispenser switch) BEFORE working
on this equipment. Failure to turn off
these power sources will result in
severe injury or death.
N
L1
L2
Install the 1uF Line Filter
Capacitor (INCON PN LSSP-LF)
Between L1 & L2
Changing the TS-LLD 1 microfarad Line Filter Capacitor
Parts Required:
1.
TS-LLD Installation Manual
(INCON P/N 000-1359)
2.
Line Filter Cap (LSSP-LF)
Tools Required:
1.
Flat-bladed & Philips head
screwdrivers (assorted sizes)
2.
Multimeter with test probes (set to read voltage at 120 VAC)
Old Line Filter – Removal Steps:
1.
DANGER 240 V AC is present !
…disconnect
electrical power as described
in the TS-LLD CU Installation & Wiring and in the Safety Chapter of that manual.
2.
Open / remove the submersible pump relay box cover.
3.
Use the multimeter to make sure NO VOLTAGE IS PRESENT from N to any
other terminal inside the relay box.
4.
Remove the old Line Filter Capacitor (INCON P/N 020-0028).
New Line Filter – Installation:
Follow the
Safety Instructions
, the installation steps for the new
CU enclosure
to install the new line filter capacitor
, and the
After Installation Steps /
Testing
(as detailed in the TS-LLD Installation Manual).
Discard the old Line Filter Capacitor
Contact INCON Technical Service Department for any additional help. Call toll free
at 1-800-984-6266.
—
❖
—