MICROCOM
®
TEMPERATURE CONTROLLER
INSTRUCTION MANUAL
©INCOE
®
CORPORATION 4/2010
Pg.
www.incoe.com
If this parameter is set at “OFF”, the
controller displays an “otc” alarm and does
not apply any voltage to the heater when a
thermocouple failure occurs.
If this parameter is set at “ON”, when a
thermocouple failure occurs , the controller
switches automatically to MANUAL mode,
modifies the manual setpoint using the
percentage of power saved, and then applies this
percentage of power on the heater.
Navigation via “Click & Rotate” switch:
If “Increase” display
If “Decrease”display
If “Selected” (Push 2 seconds):
It is possible to modify the
parameter value.
Controller parameters initialization:
This parameter allows the restore of all
parameters to factory settings.
Navigation via “Click & Rotate” switch:
If “Increase” display
If “Decrease”display
If “Selected” (Push 2 seconds):
It is possible to modify the
parameter value.
Controller locking:
This parameter allows for enabling or disabling
the locking of the controller. By default, this
parameter is set to OFF. If it is set to ON, the
“Click and Rotate” switch locks up if it remains
untouched for 30 seconds. To temporarily unlock
it, a 5 second push is required.
Navigation via “Click & Rotate” switch:
If “Increase”display
If “Decrease”display
If “Selected” (Push 2
seconds): It is possible to
modify the parameter value.
Controller State on re-start:
This parameter allows selection of the state of
the controller when the controller is re-started
when power is turned back on. If parameter is set
at “OFF” and the main power is turned off, the
controller will restart in the “OFF” mode when
power is back on.
If the parameter is set at “ON” and the main
power is turned off, the controller will restart in
the “ON” mode when power is back on.
If the parameter is set at “AII” and the main power
is turned off, the controller will restart in the state
it was prior to the main power being turned off.
Navigation via “Click & Rotate” switch:
If “Increase”display
If “Decrease”display
If “Selected” (Push 2 seconds):
It is possible to modify the
parameter value.
Parameter value: OFF, ON, or AII
(As it is).
IMPORTANT :
Any operation on the unit must be carried out by
authorized personnel only.
Any part replaced must have the same characteristics.
Remove the main power to the cabinet before servicing.
2
OPERATION
10
