SHARK
Wireless Charger - in Car or at home
Installation Guide:
(1) Package includes:
FRONT
BACK
12 V Car Adaptor
Fuse box wiring cable
Installation Guide
Main Unit
(2) Installation:
inCarBite representatives are ready to help you with any questions about your new product. We can guide
you through first time installation, simply follow below steps. We wish you to start enjoying your purchase
right away!
Select a vertical location, ideally the edge of center console (the
middle storage compartment between the front two seats of a car),
avoid air vent area or stick on the glass of vehicle or air bag that may
cause accident. To achieve best result, fully clean the edge with
Alcohol Pad, leave dry and ensure no dust is left behind. Peel off 3M
sticker on Velcro of Charger; ensure the shark mouth of charger on the
top, apply the Velcro by pressing firmly with 5KG force at least 10
seconds into place ensuring full contact over the entire area. Charger
will stay firmly after few minutes.
(A)
Simple installation:
DIY
Get power from the Cigarette Lighter:
Simply plug in the car adaptor to the car cigarette power hole and connect the other end to the charger IN
Hole.
(B)
Professional installation:
Fuse Box Wiring cable
Get power from the Fuse Box:
You can also connect the cable directly to your car’s Fuse Box if you prefer not to use your cigarette lighter.
So you need the provided long cable
f
or internal wiring that you can neatly tuck away around to Fuse Box so
as to install it in the most discreet way possible.
Connect the extension wire with the main unit wire plug, installing the wire to Fuse Box.
Open the Fuse Box and choose the right Fuse slot and take out the fuse. Plug the fuse to our adaptor at
the end or the wire and then plug the adaptor to the same right Fuse slot.
Close the Fuse Box.
Check your car’s user manual to find the correct setup.
