Enter Setup
Exit and Save
12
1s
(*)2s
5s
50s
Consecutive Scanning Mode
You don't need to push the button to trigger scanning under this mode. The red
LED is on automatically and ready to scan a barcode. If no barcodes are scanned,
the red LED will stay on. After a successful scanning, the red LED goes off first and
becomes lit again automatically.
To adjust the scanning intervals, please follow the steps below:
For example: to set the scanning mode as "Consecutive Scanning Mode" and set
the "Consecutive Scanning Interval" as 1s.
1. Read the "Enter Setup" barcode.
2. Read the "Consecutive Scanning Mode" barcode.
3. Read the "Consecutive Scanning Interval Setting" barcode.
4. Read the "1s" barcode.
5. Read the "Exit and Save" barcode.
Consecutive Scanning Mode
Consecutive Scanning Interval Setting
Содержание BCST-53
