inada HCP-G900, Руководство по эксплуатации, Страница: 20 / 52

17
[T
ROUBLESHOO
TING]
Problem Cause & Solution
The right and left
mechanism rollers are
out of alignment.
The rollers are designed with an
alternating tapping mechanism,
so in the stopped position they are
sometimes out of line. This is part of
their design and there is nothing wrong
with the chair.
T
his is par
t of the desig
n and is not a malfunc
tion.
The mechanism moved
to the leg section and
stopped.
● If a weight that exceeds a certain value is placed on the equipment,
the course may force terminate before completion. Set the
reclining angle to the zero gravity angle for massage.
(There is an audio announcement if the course is terminated as
above.)
● When massage is terminated by the auto timer function, the
mechanism moves to the leg section to prevent interference.
(There is an audio announcement when the course is terminated.)
During kneading, the
rollers sometime skip.
When a person is on the chair, the rollers may catch at the edge of the
body where bodyweight is applied to the mechanism. The rollers may
also catch due to individual diff erences in bodyweight and shape.
The mechanism stops
during the massage.
If the motor becomes hot, the safety mechanism raises the reclined
seat back and stops all operations.
Turn the main power switch OFF, and wait for a while before switching
the main power switch ON again.
The button of the
remote controller and the
program button fl ash.
Set the main power switch located at the front right of the chair to
OFF, and then back ON after about 5 seconds.
If ther
e is still a pr
oblem af
ter the check
, st
op using the
pr
oduc
t immediat
ely
.
The automatic shiatsu
point locator function is
not working properly.
(The height of the mechanism does
not match the shoulders.)
Sit further back in the chair so that your head rests fi rmly on the
headrest. You can adjust the shoulder position with the Roller button
immediately after the shiatsu points are located.
Remote controller
buttons do not seem to be
operating normally. Or the
power does not turn on.
Check for the following:
① Is the power cord fully plugged into the wall outlet?
② Is the main power switch located on the right side of the chair set
to ON?
③
Are you pressing two buttons at the same time?
The power cord or plug
is abnormally hot.
Stop using immediately.
Contact the vendor for assistance.
Anyone other than an
authorized serviceperson must
not repair or disassemble.
TROUBLESHOOTING
If there is still a problem after trying the solutions given in this troubleshooting guide, stop using the chair immediately
to prevent accident or injury, and unplug the power plug from the wall outlet. Contact the vendor for assistance.
1.5 cm
(0.6 inch)
1.5 cm
(0.6 inch)