800-446-7488
19
www.in-situ.com
3. Click the
Activate modem
button.
4. Select the GSM band for your geographical area and click the
Set GSM band
button.
5. Select whether your network is 2G or 3G and click the
Set network
button.
6. Click the
Verify SIM and PIN
button.
7. Click the
Show signal quality
button if you are near your deployment area.
8. Click the
Deactivate modem
button.
9. Close the window.
SIM Card
Cube 300 units require a SIM card for communication over the wireless network.
If you are managing your data plan through In-Situ, a SIM card is installed in the equipment prior to shipment.
If you are managing a data plan through a third party, you must obtain a SIM card from their service provider and install it yourself.
Consider if your application requires a static IP address when purchasing the SIM card.
Once a SIM card is obtained, install it in the Cube as shown below.
The SIM card slot is located between the two circuit boards, next to the circular cutout closest to the battery terminal.
1. Align the SIM card so the diagonal cut is facing away from the circuit board and the gold chip is facing the round cut.
2. Gently insert the card into the slot and push in fully.
SD Card
The Cube has a 512 MB SD Mini memory card installed. The system will not function without an SD card.
Warranty
In-Situ warrants the Cube Telemetry System for one year from date of shipment by the end user against defects in materials and
workmanship under normal operating conditions. To exercise this warranty contact Technical Support for a Return Material
Authorization (RMA) and further instructions. Complete warranty provisions are posted on our website at
www.in-situ.com
.
