IMT 70735257, Руководство пользователя

Страница: 16 / 29

Battery Installation 12 Section - 4
SII Telscopic -
Battery Installation / Replacement
1. The handheld remote unit is powered by four-size AA alkaline batteries. When installing batteries, be sure to
observe proper polarity as marked on the inside of the compartment to avoid damaging the unit. To replace
or install batteries in the handheld:
2. Loosen the four Phillips battery compartment cover screws on the rear of the remote. Lift the cover form the
handheld.
3. Install or replace with four (4) fresh size AA alkaline batteries. Observe the proper polarity by positioning the
batteries as indicated in the battery compartment.
4. Replace the compartment cover and tighten the four (4) Phillips screws. These screws should not be over
tightened, but they must be tight enough to assure the gasket provides a proper seal
CAUTION
Observe proper polarity when
placing batteries into the cradle.
Improper battery placement can
result in excessive heat, battery
explosion, injury to the operator,
and damage to the remote.
06/15/2022 SII Telescopic Proportional Electric Crane Radio Remote