![background image](http://html.mh-extra.com/html/ims/medio/medio_installation-manual-and-operating-instructions_2049868008.webp)
8
•
Render a top coat over the green mesh. Use the remaining render
from Step 10 (render may need remixing if left to sit between
Step 10 and Step 12).
Equipment:
•
Mixing vessel/bucket
•
Electric paddle mixer (slow speed)
•
Stainless Steel smoothing trowel, spatula,
notched trowel
Method:
•
Application temperature 5˚C- 30˚C
•
Do not apply if frosty/raining or frost/rain are anticipated
•
Mix 5.1 litres of water per 30kg bag
•
Thoroughly mix the product until it is an even
consistency
•
Rest mix for five minutes before applying
•
Using the notched trowel apply a layer of render
•
Allow the render to thoroughly dry for 24 hours
minimum before further application
Cleaning:
•
Tools & hands should be washed with water before the
product dries
Consult:
•
Parex Maite data sheet for further detailed supplier
information
Step 12
Piccolo shown
•
Check the colour marked on the primer label matches the colour
listed on the fine sand finish and is as ordered.
•
Prepare the DPRprimer and cover the render in an even coating
Equipment:
•
Woollen roller or brush
Method:
•
Application temperature 5˚C- 30˚C
•
Do not apply if frosty/raining or frost/rain are anticipated
•
Thoroughly mix the product until it is an even
consistency
•
Avoid creating air bubbles or foam
•
DPRprimer must be completely dry before any finish is
applied
•
Allow the DPRprimer to thoroughly dry for 2 to 12
hours, depending upon ambient temperature and
humidity
Cleaning:
•
Tools & hands should be washed with water before the
product dries
Consult:
•
Parex DPRPrimer data sheet for further detailed
supplier information
Step 13