I-Control manual
page 34
I-Control software update
The I-Control software can easily be updated if necessary. To update, a micro Sd memory card is required. The Sd
card must be FAT16 or FAT32 formatted. The capacity of the Sd card can be up to 32GB.
Updating the I-Control is as follows:
1
Using your PC, copy the update file to the micro Sd
card. The file should be placed in the root directory and
not in a folder on the Sd card.
2
Make sure there is no backup file from any previous
backup on the Sd card. Delete any previous backup
files, which are those with .BCK and .USED extensions.
3
Insert the Sd card into the connector. See upper
picture.
4
Press the SW1 button located on the bottom printboard
of the I-Control. See lower picture.
5
The I-control writes all the set functions on the Sd card,
which is indicated by the flashing ADDR-led.
6
Thereafter, the I-control starts the boot program and
the update is performed. The display will show this
process.
7
Once the update is completed, the user program
automatically starts.
8
Thereafter, the functions saved on the Sd card are
replaced in the relevant functions. Any "new" features
in the new software will be set to the default.
9
The I-control is updated and ready for use.
Restoring factory settings
To reset the settings to the factory settings, proceed as follows:
1
Turn off the power.
2
Press the SW1 button on the bottom printboard and keep it
pressed while the power is turned on.
3
Keep this button pressed for at least 30 seconds until the
run-indicator blinks at one second intervals.
4
The factory settings are now restored.
Sd-card
SW1 button
SW1 button
