IMO HD2 IP Series, Инструкция по эксплуатации

Страница: 46 / 361

HD2 IP55 High-ingress Protection Series Inverters Basic Operation Instructions
-34-
5.3.3 Fault alarm display state
The inverter enters fault alarm display state once fault signal is detected, and the keypad
displays fault code and fault information with TRIP indicator on the keypad turning on. Fault
reset operation can be done by STOP/RST key, control terminal or communication command.
The fault code will be kept displaying until fault is removed.
Figure 5-7 Fault alarm display state
16:02:35 Forward Local Fault 01: HD2IP
Type of present fault:
Fault code
：
19
19
：
Current detection fault (ItE)
Return Homepage
Confirm
5.4 Keypad operation
Various operations can be performed on the inverter, including entering/exiting menu,
parameter selection, list modification and parameter addition.
5.4.1 Enter/exit menu
Regarding the monitoring menu, the operation relation between enter and exit is shown below.
Figure 5-8 Enter/exit menu diagram 1
16:02:35 Forward Local Ready 01: HD2IP
Set frequency
P17.00 Hz
50.00
DC bus voltage
P17.11 V
540.0
Digital input terminal state
P17.12
0x0000
Monitoring About
Menu
16:02:35 Forward Local Ready 01: HD2IP
Stop state display parameter
Running state display parameter
Return Homepage
Select