IMCO Xtreme Advantage, Руководство по эксплуатации и ремонту

Страница: 3 / 13

Cutting Transom
1. Using the provided template or using the Bravo Drilling fixture that can be purchased through a Mercury
MerCruiser Dealer can determine the transom cutout size. (Angle holes for tiller arm are not necessary
with Xtreme Advantage Gimbals).
2. Propeller height or crankshaft centerline is best determined by the hull manufacture or by previous testing.
3. Transom thickness must be between 2” and 2 ¼ ”.
Xtreme Advantage Gimbal Installation
1. Remove gimbal from shipping carton and remove plywood backing plate.
2. Remove all packing materials, retain steering ram restraints. (Do not allow steering rams to damage paint-
ed surfaces.)
3. Position gimbal housing onto transom and hold in place.
4. Secure inner and outer transom pieces together with 8 - 7/16 washers and 8 - 7/16 nylock nuts provided.
5. Tighten fasteners in small increments in a criss cross pattern to 23 ft lbs.
IMPORTANT: When installing gimbal to IMCO extension box the two upper studs
need to be 2 ¾ ” for EB - 12 - N and EB - 12 - 3 and 2 ¼ ” for EB - 14 - T extension box ’ s.
Trim Pump Hose Hookup
1. Use provided hoses to hookup trim pump as pictured below.
2. Fill oil through oil fill cap as shown.
05 - 8035
Trim hose up
05 - 2381
Trim hose down
Page 1
Oil Fill