IMB MB2003D-KS-1509P, Инструкция по эксплуатации

Страница: 16 / 27

12
Blow 3&4：Blowing operation, bottom line off line，When the pants piece leaves the first
piece of reflective paper, the blowing starts according to the number of delayed stitches；
Rear cut：The pants piece leaves the second piece of reflective paper and starts cutting
according to the number of delayed stitches。
6.3 Front and rear roller pressure
1. Front roller pressure：Manually rotate the pressure regulating knob of the left pressure
reducing valve (as shown in the figure below)，The pressure of the roller is maintained
at 0.3-0.4mpa. If the pressure is too small, the roller fails and affects the needle pitch。
2. Rear roller pressure；Manually rotate the pressure regulating knob of the right pressure
reducing valve (as shown in the figure above), the tugboat pressure is maintained at
0.3-0.4mpa。if too small affects the shear position.