Imagine VTM6801+, Инструкция по установке и эксплуатации

Страница: 43 / 52

VTM6801
+
Installation and Operation Manual 29
Appendix A: Communication and Control Troubleshooting Tips
Control and Monitoring Using CCS Software
Before using CCS software applications to control and monitor your
module, you must refresh (
+
Pilot Lite) or discover (Pilot and
Navigator) the module. Refresh and Discovery are the processes by
which your CCS software finds, and then connects to your module.
Refreshing Your Module Using
+
Pilot Lite
When using
+
Pilot Lite to change your VTM6801
+
control
parameters, you must “refresh” the control connection between your
6800
+
frame and PC. To refresh the connection, from the
+
Pilot Lite
menu bar, select File > Refresh . For information about controlling a
device using
+
Pilot Lite, see your
+
Pilot Lite User Manual .
Discovering a VTM6801
+
Module
To discover your module, your Pilot or Navigator software must be in
Build mode. Follow these steps:
1. If the Discovery window is not open, click Tools > Discovery in the
main menu.
A Discovery window opens, most likely in the bottom left corner of
the screen.
2. Click Options , and then click Add .
3. Enter the IP address of the frame that contains your module, the
frame that contains your ICE6800
+
module, or the frame that
contains a 6800
+
ETH module that provides access to your module.
4. Click OK to close the Add IP address window, and then OK again
to close the Discovery Options window.
5. Click Start .
This triggers Pilot or Navigator to run a discovery.
6. When your discovery is complete, Discovery Completed is
displayed in the Discovery window. To continue, click Save , to
save the contents of your discovery to the Discovery folder of the
Navigation pane.
You can now switch to Control mode by selecting Operational Mode >
Control from the main menu. Double-click VTM6801
+
in the
Navigation pane. The Control window opens, displaying the module’s
controls.